Home Automated Living Forums

Home Automated Living Forums (https://www.automatedliving.com/forums/index.php)
-   X10, UPB, Z-Wave and Insteon (https://www.automatedliving.com/forums/forumdisplay.php?f=19)
-   -   Sprinkler Controller (https://www.automatedliving.com/forums/showthread.php?t=5581)

radiodyne 05-26-2015 04:35 PM

Sprinkler Controller
 
What sprinkler controllers interface with Hal? I have gone through the various devices and cannot see that a sprinkler controller is listed. I had two EZIO8SA's interfaced through Hal, and both died. They seemed rather "clunky" so am reluctant to replace them with the same ones. I am looking at the WGL Rain8UpbPro.. Suggestions?

Thanks,

Steve

DaveGA 06-06-2015 07:10 PM

Re: Sprinkler Controller
 
Hi Steve,

I currently use 2 rain 8 X10 modules that have been working fine for about 5 years. I set them up as I1-16 in HAL. With this configuration you do require a serial connection to the X10 Rain 8's to configure their initial addresses, but once done, they seem to work fine.

Good luck!

dave

radiodyne 06-08-2015 07:02 PM

Re: Sprinkler Controller
 
Thanks Dave. I have settled on six UPB UMI-32 modules and a 12 relay module. Will set up rules and schedules.

Thanks again,

Steve


All times are GMT -6. The time now is 03:14 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
© 1995-2017 Home Automated Living. All Rights Reserved.