Re: 6.1.30 Upgrade
So I can tell you that I had a similar problem with the .30 release but after doing a second re-installation the issue went away.
Now I have another issue, which I haven't reported yet... Just not enough hours in the day...
I get a periodic pop-up window that says HAL is doing maintenance, to standby and some system impact may occur, etc. That message will never go away. I have to shut down HAL and restart it. It then will pop back up in a few days again and will never finish the maintenance cycle for some reason.
Never had this problem before and I need to report it to AL to see if they have a solution.
Hopefully a reboot, and re-install fixes your issue where HAL won't ever start up. I'm running HALPro v6xxx.30.
Jeff
|