Thread: 2441TH and HAL
View Single Post
Old 02-15-2017, 10:51 AM   #1
Advanced Member
Join Date: Aug 2003
Location: Salina, KS
Posts: 154
Default 2441TH and HAL

Just replaced an unreliable Venstar with Insteon adapter with the newer 2441TH.

Went to program this in HAL, and when I enter the Insteon ID and hit program, HAL just sits there at the "Please wait..." prompt for an unknown amount of time. I usually wait about 5 minutes before giving up and hitting apply and then done.

HAL read the thermostat ONCE, but now, the reading is stuck at 64 degrees, which is what the first reading was, no matter what the temperature really is.

Should it take over 5 minutes to program the thermostat? Any fixes for this?

(The Insteon portion of the thermostat is working, because I can control it with the Insteon Hub without any issues).


DevenLF is offline   Reply With Quote