Keypadlinc Buttons - Insteon

carlh6902 · 09-15-2016, 09:32 PM

I am trying to figure out how to control the LED on a Keypadlinc button in Hal. I have some buttons set up as sensors, to trigger events. Need to be able to control the status of the LEDs as well. Has anybody successfully achieved this using HAL and a PLM interface? If so, please let me know how you did this.

Carl

DevenLF · 09-26-2016, 10:02 PM

There was an excellent thread about this on the previous webboard. Unfortunately, I guess that is lost.

Although I can no longer tell you how to do it, I will say that it IS possible, as I used to have it working well. Then, my HAL db got corrupted and I lost those conditional rules, and nobody can tell me how to make it work again. Too bad that old HAL webboard is gone

09-15-2016, 09:32 PM	#1
carlh6902 Member Join Date: Aug 2003 Location: Olathe, KS Posts: 80	Keypadlinc Buttons - Insteon I am trying to figure out how to control the LED on a Keypadlinc button in Hal. I have some buttons set up as sensors, to trigger events. Need to be able to control the status of the LEDs as well. Has anybody successfully achieved this using HAL and a PLM interface? If so, please let me know how you did this. Carl __________________ "I'm an excellent hardware man, and I don't know why you're smirking. I did not know it was not turned on, I thought that it wasn't working."

09-26-2016, 10:02 PM	#2
DevenLF Advanced Member Join Date: Aug 2003 Location: Salina, KS Posts: 154	Re: Keypadlinc Buttons - Insteon There was an excellent thread about this on the previous webboard. Unfortunately, I guess that is lost. Although I can no longer tell you how to do it, I will say that it IS possible, as I used to have it working well. Then, my HAL db got corrupted and I lost those conditional rules, and nobody can tell me how to make it work again. Too bad that old HAL webboard is gone

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)