X10, UPB, Z-Wave and Insteon This forum is for topics related to X10/Z-Wave/UPB/Insteon configuration with HAL. |
|
Thread Tools | Display Modes |
![]() |
#1 |
Junior Member
Join Date: Feb 2009
Posts: 17
|
![]()
If the old forum posts were available, I probably wouldn't have to ask these questions. But they aren't, so...
What are the SmartHome interface models #s that are supported in v6? I'm guessing 2412/2413S 2412/2413U 2448A7 I have the last one (2448A7). I get stuck adding a device. I tried to add a KeypadLinc dimmer, both by putting the KPL in linking mode and by address. Either way, it never finishes. The interface works just fine in the SmartHome HouseLinc software. I also have an ACT ZCU000 z-wave interface. I can't add it to HAL. When I select it, it asks for the serial port it's connected to, even though it's a USB device. Can't get past that. Is it true that this and the Intermatic stick, both discontinued, are the only supported z-wave devices? I thought there was support for the VRC0P, but it isn't in the list. -Tom |
![]() |
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
|
|
|