[DaveGA]

Hi All,

I recently updated the firmware in my NAPCO GEM 9600 Security panel to Version 61B (home automation) and am having some strange issues.

1) HAL can access the panel and correctly reads the READY NOT READY state of the system
2) HAL does not read all the sensors I have loaded for each zone. It reads some, but not all.
See attached screen grab.
3) When I remove a sensor that worked and then reconfigure, it also can no longer read the status.

I was using HA firmware version 40C, but had to upgrade for a systems keypad upgrade.

Thoughts:
- Do I have something corrupt somewhere in HAL related to the NAPCO device?
- Does Version 61B Firmware not work with HAL Ultra?
- Am I crazy??????

Any input would be great!

Thanks!

dave
Hal Ultra 6.0.60
Win 7
GEM9600