X10, UPB, Z-Wave and Insteon This forum is for topics related to X10/Z-Wave/UPB/Insteon configuration with HAL. |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Junior Member
Join Date: Jan 2015
Location: Kalispell, MT
Posts: 9
|
![]()
What sprinkler controllers interface with Hal? I have gone through the various devices and cannot see that a sprinkler controller is listed. I had two EZIO8SA's interfaced through Hal, and both died. They seemed rather "clunky" so am reluctant to replace them with the same ones. I am looking at the WGL Rain8UpbPro.. Suggestions?
Thanks, Steve |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Dec 2006
Location: Athens, Ga
Posts: 52
|
![]()
Hi Steve,
I currently use 2 rain 8 X10 modules that have been working fine for about 5 years. I set them up as I1-16 in HAL. With this configuration you do require a serial connection to the X10 Rain 8's to configure their initial addresses, but once done, they seem to work fine. Good luck! dave |
![]() |
![]() |
![]() |
#3 |
Junior Member
Join Date: Jan 2015
Location: Kalispell, MT
Posts: 9
|
![]()
Thanks Dave. I have settled on six UPB UMI-32 modules and a 12 relay module. Will set up rules and schedules.
Thanks again, Steve |
![]() |
![]() |
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|
|