Message Board

X10, UPB, Z-Wave and Insteon This forum is for topics related to X10/Z-Wave/UPB/Insteon configuration with HAL.

Reply
 
Thread Tools Display Modes
Old 05-26-2015, 04:35 PM   #1
radiodyne
Junior Member
 
Join Date: Jan 2015
Location: Kalispell, MT
Posts: 9
Default Sprinkler Controller

What sprinkler controllers interface with Hal? I have gone through the various devices and cannot see that a sprinkler controller is listed. I had two EZIO8SA's interfaced through Hal, and both died. They seemed rather "clunky" so am reluctant to replace them with the same ones. I am looking at the WGL Rain8UpbPro.. Suggestions?

Thanks,

Steve
radiodyne is offline   Reply With Quote
Old 06-06-2015, 07:10 PM   #2
DaveGA
Member
 
Join Date: Dec 2006
Location: Athens, Ga
Posts: 52
Default Re: Sprinkler Controller

Hi Steve,

I currently use 2 rain 8 X10 modules that have been working fine for about 5 years. I set them up as I1-16 in HAL. With this configuration you do require a serial connection to the X10 Rain 8's to configure their initial addresses, but once done, they seem to work fine.

Good luck!

dave
DaveGA is offline   Reply With Quote
Old 06-08-2015, 07:02 PM   #3
radiodyne
Junior Member
 
Join Date: Jan 2015
Location: Kalispell, MT
Posts: 9
Default Re: Sprinkler Controller

Thanks Dave. I have settled on six UPB UMI-32 modules and a 12 relay module. Will set up rules and schedules.

Thanks again,

Steve
radiodyne is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.