Message Board

HVAC (Thermostats) This conference is for topics related to HAL's HVAC features and the third-party HVAC controllers that can be used with HAL.

Thread Tools Display Modes
Old 02-15-2017, 10:51 AM   #1
Advanced Member
Join Date: Aug 2003
Location: Salina, KS
Posts: 154
Default 2441TH and HAL

Just replaced an unreliable Venstar with Insteon adapter with the newer 2441TH.

Went to program this in HAL, and when I enter the Insteon ID and hit program, HAL just sits there at the "Please wait..." prompt for an unknown amount of time. I usually wait about 5 minutes before giving up and hitting apply and then done.

HAL read the thermostat ONCE, but now, the reading is stuck at 64 degrees, which is what the first reading was, no matter what the temperature really is.

Should it take over 5 minutes to program the thermostat? Any fixes for this?

(The Insteon portion of the thermostat is working, because I can control it with the Insteon Hub without any issues).


DevenLF is offline   Reply With Quote
Old 02-19-2017, 11:26 AM   #2
Advanced Member
DadGoneMad's Avatar
Join Date: Jun 2007
Location: Katy, TX
Posts: 199
Default Re: 2441TH and HAL

Hey there,

I just installed two of these in my home. I did the same process you mentioned but when it completed I had multiple 2441TH's as different devices. I deleted all the duplicate thermostats, then put in the Insteon ID when adding it again and then clicked on "Program". It took only a few seconds and was done, I've been using these new 2441TH thermostats for over a week now with HALPro and have had no issues at all.

Hope this helps,

DadGoneMad is offline   Reply With Quote


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.