Help Desk

Ask a question:
» Category: Troubleshooting - Device Control  (Go back)


» Articles in this category:

I told HAL to turn a light on, but it didn't work. Article rated 3.4/5.0
Related Product(s): All HAL Software Cause: The wrong name was used for controlling that light. Solution: Double-check that you're using the correct name for th...
It is taking HAL at least 5 seconds to dim a light. Article rated 3.4/5.0
Related Product(s): All HAL Software Cause: The device was configured to brighten the light fully to turn on or dim. If you tell HAL to dim a light and it was configured to use the...
I tell HAL to turn a light or appliance on, but it only seems to work some of the time. Article rated 3.0/5.0
Related Product(s): All HAL Software Cause: HAL's listening mode "timed out". If HAL doesn't hear any commands within a set time period, then HAL will ask, "Are you still there?" I...
I asked HAL the status of a device, but it says that information is unavailable. Article rated 3.0/5.0
Related Product(s): All HAL Software Cause: The device is not connected to a two-way X-10 receiver that has the status request feature. Solution: Replace the ex...
I told HAL to dim a light to a certain level, but it doesn't seem to be at the level I requested. Article rated 3.4/5.0
Related Product(s): All HAL Software Cause: HAL wasn't configured to reset the light before it dims it. The X-10 protocol has 16 dim levels, or about one (1) dim level per six perc...

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid